#LOGITECH Z906 BASS CONTROL INSTALL#

#LOGITECH Z906 BASS CONTROL INSTALL#

You can install the speakers around the steering wheel and above the monitor, or at the four corners of the rig without any issue.Ĭoncerning the subwoofer, we prefer to put it in front or behind the simulator. Many brackets are available on Amazon, and personally I use 3D printed brackets that I will share soon. The satellite speakers can be attached from the back where there is an UNC 1/4″ screw thread. To make the installation cleaner, I advise you to use this kind of braided cable. Logitech supplies 4.6m and 7.6m audio cables. Installing the speakers is simple: just connect the speakers to the corresponding ports on the subwoofer (which integrates the amplifier), then connect the control box to the subwoofer via the VGA socket. If this is not the case, again, you will need to add an internal or external sound card.

It is also the most economical solution because many motherboards that do not offer RCA 5.1 include an optical output. Optical: probably the most practical since it requires only one cable.Just use it as an AUX to use with your phone by example. RCA : only for 2 channels so forget it.To do this, you must have a motherboard with RCA 5.1 or add an internal or external sound card. You will need to use three 3.5mm jack cables (5.1 = 6 channels). 3.5mm Jack: Basic solution but still effective.

It can be connected in the following ways: First, you need to decide how you’re going to get the Z906 to communicate with your source. The software configuration of the Logitech Z906 is “pretty” simple.

Logitech z906 bass control